I have run into a problem where I cannot see or adjust camera properties (both GigE and USB cameras) on some computers in our lab. On 'good' computers I can adjust properties, perform a snap or grab, etc.; but on the problem machines the camera(s) show up in the list of devices in NI-MAX, but snap, grab, the tabs for adjusting properties, etc. are missing/not-available. There is no red-mark or other indication of problems in NI-MAX, we just don't have camera options available. (screen grabs are attached).
These are identical Dell computers running windows 10.
Even on the problem computers I can see that the cameras are working properly in the driver software provided by the camera manufacturer. I'm able to perform the equivalent of a 'grab' in the vendors software.
I've tried comparing all the installed software, updating firmware, reloading drivers, running CameraValidator, etc. but still have no clue what is going on. - My GigE cameras are the Allied Vision MANTA series, and USB cameras are Matrix Vision BlueFOX
Thanks for any suggestions you can offer