Hello community,
I am having an issue when trying to run two Basler GigE cameras through the same ethernet hub to my computer. I have a snap test file that is supposed to take as many pictures as I want but after one photo I receive the error "camera has been removed" even though the pictures are displayed on the front panel. Attached is a screenshot of this issue.
I also have a video test file that is the actual goal of my research but I suspect that whatever causes the error in the snap test is preventing me from beginning a video session. I get error 1074360306 "No acquisition in progress" and then repeated error 1074360308 until I stop the file. I've attached a screenshot of this issue as well.
I tried changing the packet size in NIMAX, it didn't help. I tried changing the desired peak bandwidth also in NIMAX and it made other errors pop up. I have reviewed the two support pages https://knowledge.ni.com/KnowledgeArticleDetails?id=kA00Z0000019KwgSAE&l=en-US and https://knowledge.ni.com/KnowledgeArticleDetails?id=kA00Z000000g1BiSAI&l=en-US
My switch is a Netgear GS316 which supports jumbo frames up to 9216 bytes.
Both my codes are attached but please let me know if any other information would be helpful, any assistance would be much appreciated.
Thank you!