I have Vision Builder 2018 SP1 (32-Bit) LabView 2018 SP1 (32-bit) and Vision Development Module 2018 SP1 (32/64 bit), installed on a 64-bit system. This is all VBAI says it needs to perform the migration.
However, when I try to run the migration, it allows me to confirm the version of LabView and select a destination folder, and when I click OK, VBAI turns light gray (disabled/busy) and LabView launches, but after about 45 seconds, VBAI returns to normal state, and there is nothing in the target folder I selected? No, error messages either. During the non-conversion LabView never appeared busy, it simply launched and started its regular display of scrolling suggestions...
Any ideas for getting the conversion process to work?
Thanks,
Eric