Hi All,
I am very new to NI vision builder and Arduino and was hoping if someone can help me in resolving few of my concerns below.
I am trying to:
- Use a digital input received by the arduino controller to capture a image and initiate inspection.
- Output (fail or pass) from the NI Vision back to arduino for further actions
- All of the above communication is happening over Modbus TCP
Issues I have been having:
- I have not been able to establish any form of communication between the controller and the NI Vision software.
- Do not have any idea how to debug the communication related issues.
It will be very helpful if someone can help me understand the basic steps/checks I can refer to in order to resolve this communication issue.
Thank you for your help!